Refresh table when clicking on a chart

Most likely you are not passing a good value to your condition.  Take a look at this forum post that describes the values available in merge syntax to pass into your condition.  https://community.skuid.com/t/chart

I often add a “block ui and show message” action in my sequence with the merge syntaxt I am using to pass into a subsequent step in order to ensure I’m actually getting the values I want. 

One complication in what you are looking to do is that once the table is filtered down,  there is not a good way to reset the condition within the chart.  You’ve drilled in,  but now are stuck in your hole!  Options:
- Make the table open in a popup, and adding actions to a “cancel” button that disactivates the condition and requieries the model.
- Add a global action to the table that refreshes the table.  
- Put the chart / table combination in a wizard with the “back” button in the drilled down wizard step bound to the disactivation / requery combination.